TermX 50m Termite Reticulation Hose Kit - Professional Grade - DIY

TermX reticulation hose, Australian product – in-slab or perimeter piping that lets a termite barrier be recharged with termiticide without trenching or drilling. 

What's included in the kit

• 50 m red PVC chemical-resistant hose (internal fibre matting, rated to 600 PSI). Codemark Certified as a building product and burst rated up to 1800 psi. Typical fill pressure up to 100 psi
• All required fittings for 3 lengths - Stoppers, clamps, hose connectors. No extra hardware required (unless you need more than 3 lengths eg 5 x 10m lengths contact us to purchase more fittings or you can use standard hardware store irrigation fittings also). 
• 3 (black) manifold boxes with lids.
• TermX homeowners brochure (PDF also available below)

Termiticide is sold separately – see our other listings for Fipronil or Bifenthrin options.

Key facts

• Manufacturer: MDS Pty Ltd
• Construction: Red PVC chemical-resistant hose with internal fibre matting, rated to 600 PSI
• Use: Delivery system only – termiticide sold separately
• Certification: CodeMark certified CM 30022 Rev 4
• Pack size: 50 m kit

Basic setup overview

1. Plan your run lengths – each run must be 15 m or less (shorter runs are fine).
2. Lay the hose – bury approximately 100 mm deep or at the edge of the footing; wrap around pipes and obstacles as needed.
3. Connect the manifold boxes – the 3 manifold boxes supplied act as service points for future recharging.
4. Fit end caps and fittings – use the included fittings to terminate each run.
5. Recharge when needed – pump termiticide through at up to 100 PSI; standard garden hose pressure also works.

Tip: If you are pouring concrete paths around your building, install TermX first (after boxing is done but before the pour).

Note: The hose colour has changed to red since the original video was produced.

Compatibility and fit checks

• Termiticide: Works with any registered termiticide (Fipronil, Bifenthrin, or other – apply at label rate).
• Pump pressure: Compatible up to 100 PSI; garden hose pressure is sufficient.
• Run length: Maximum 15 m per run; plan manifold positions accordingly.
• Installation type: Suitable for new builds (in-slab) and existing buildings (perimeter).
• Hose flexibility: Can be bent around corners and wrapped around pipes and obstacles without fittings.

Warranty

• CodeMark certified.
• Applied according to label directions, this product is designed to perform as stated on the label, whoever installs it.
• Manufacturer warranties are separate – they generally apply only when a licensed pest technician installs the system. A warranty may not apply to DIY installations.

More about DIY installs and manufacturer warranties

Not sure if this is right for your job?

We're happy to help. Send us a photo of your site and a brief description of what you need, and we'll advise on the best setup.

• Call us: during business hours
• Email or enquire: use the Contact us page

Product documents

• TermX homeowners brochure (PDF)

Always read and follow the product label before use.